Services
Services
The measurement and calibration disciplines available through Nashville CMM Calibration and Repair.
What Is Offered
Three services cover the coordinate measuring machine and gaging equipment found on most inspection floors: calibration and repair, programming, and gage calibration.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
CMM Calibration and Repair
Accredited calibration, as-found data and repair for bridge, gantry, cantilever and portable arm CMMs.
CMM Programming
Part program development and revision for new inspection routines and updated part prints.
Gage Calibration
Calibration of granite surface plates, gauge blocks, and ring and plug gauges used alongside CMM inspection.
How the Service Is Delivered
Work is performed under ISO/IEC 17025:2017. Methods, ranges and measurement points are agreed against the request before anything is measured. The certificate or report issued afterwards states the method used, the measurement conditions and the uncertainty that applies.
Coverage across Nashville, TN and the wider Middle Tennessee and the Upper South area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.